This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register

Caliper2PC > English > Software > Interface not recognized in the software >

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Interface not recognized in the software
Ben Offline
Junior Member

***
Posts: 6
Threads: 1
Joined: Mar 2019
Reputation: 6
#1
03-06-2019, 07:34 AM
I have installed the Caliper2PC software on my PC and connected the interface to the USB port. The interface is not recognized in the software. The USB bullet shows red.

Any help appreciated.
 
Reply
Jack Offline
Junior Member

***
Posts: 6
Threads: 1
Joined: Feb 2019
Reputation: 0
#2
03-06-2019, 10:20 AM
Did you install the USB driver correctly?

The driver signature enforcement must be disabled before the driver can be installed. Just follow this manual.
 
Reply
Ben Offline
Junior Member

***
Posts: 6
Threads: 1
Joined: Mar 2019
Reputation: 6
#3
03-07-2019, 08:20 AM
Thank you Jack, that did the trick.
 
Reply
  


Forum Jump:


Browsing: 7 Guest(s)