This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register

Caliper2PC > English > Software > Lathe Setup >

Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Lathe Setup
Tomer Offline
Administrator

*******
Posts: 40
Threads: 2
Joined: Feb 2019
Reputation: 3
#8
05-14-2021, 05:23 AM (This post was last modified: 05-14-2021, 05:30 AM by Tomer.)
The top slide's 2X multiplier feature calculates the values coming from the compound slide encoder. Within your setup there is no compound slide encoder and thus calculation is not applied. The 2X feature can be enabled this way:

1. Open the Control Panel: "Display" -> "Control Panel"
2. Click the "Inc / Abs" button to set the operation mode to INC
3. Select Channel 2 from the drop down box (as your X axis is set to Channel 2)
4. Click the "2X" button to enable the 2X feature for Channel 2
5. Click the "OK" button to close the Control Panel

   
 
Reply
  


Messages In This Thread
Lathe Setup - by Matthew - 04-22-2021, 08:39 PM
RE: Lathe Setup - by Jack - 04-24-2021, 05:52 PM
RE: Lathe Setup - by Tomer - 05-02-2021, 09:08 AM
RE: Lathe Setup - by Matthew - 05-04-2021, 09:46 PM
RE: Lathe Setup - by Matthew - 05-06-2021, 09:23 PM
RE: Lathe Setup - by Tomer - 05-09-2021, 11:23 AM
RE: Lathe Setup - by Matthew - 05-13-2021, 11:22 PM
RE: Lathe Setup - by Tomer - 05-14-2021, 05:23 AM
RE: Lathe Setup - by Matthew - 05-14-2021, 09:05 PM

Forum Jump:


Browsing: 1 Guest(s)