I realized the Caliper2PC interface has output ports and would like to use some of them to turn my machines' engines on and off. I though about using relais for the power side.
Any advice?
|
Thread Rating:
|
| Messages In This Thread |
|
Using Caliper2PC DRO to turn on my lathe's engine - by Lorenzo - 03-16-2019, 05:52 PM
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Ben - 03-17-2019, 07:50 AM
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Tomer - 03-20-2019, 08:39 AM
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Lorenzo - 03-20-2019, 10:36 AM
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Ben - 03-24-2019, 10:02 AM
|
Browsing: 2 Guest(s)