This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register

Caliper2PC > English > Hardware > Using Caliper2PC DRO to turn on my lathe's engine >

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Using Caliper2PC DRO to turn on my lathe's engine
Ben Offline
Junior Member

***
Posts: 6
Threads: 1
Joined: Mar 2019
Reputation: 6
#2
03-17-2019, 07:50 AM
The output ports of the Caliper2PC interface have 5V levels (0V = low, 5V = high). A relais with optocoupler that works on 5V can be used to switch your motors.

These relais cards can be found on eBay or on Aliexpress see attachment.


Attached Files Image(s)
   
 
Reply
  


Messages In This Thread
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Ben - 03-17-2019, 07:50 AM

Forum Jump:


Browsing: 8 Guest(s)