This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
English
Deutsch
Hello There, Guest! Login Register

Caliper2PC > English > Hardware > Using Caliper2PC DRO to turn on my lathe's engine >

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Title: Using Caliper2PC DRO to turn on my lathe's engine
Lorenzo Offline
Junior Member

***
Posts: 2
Threads: 1
Joined: Mar 2019
Reputation: 0
#4
03-20-2019, 10:36 AM
Why are there 3 connectors GND, IN and Vcc on the relais card? Huh
 
Reply
  


Messages In This Thread
RE: Using Caliper2PC DRO to turn on my lathe's engine - by Lorenzo - 03-20-2019, 10:36 AM

Forum Jump:


Browsing: 2 Guest(s)