Greetings Everyone and Thank You Tomer for accepting me to this Forum! I have had my Caliper2PC for almost 10 years but have only used it a few times and recently I have a lathe project inwhich I need its Lathe DRO. Well long story short all the Ports work fine 1-6 and I can plug into them and see that my scales read fine. I only have 2 scales on my lathe X and Y, I have not installed one on the Angle slide yet which is fine for now. I can get Z to read on the Lathe DRO screen fine just not the X axis even when I select what Port it is on, sometimes it conflicts with the cross slide also. Any help in the settings would be appreciated. It worked fine before but that was well a long time ago and I forgot how to do it. Thanks in advance for any help!
|
Thread Rating:
|
| Messages In This Thread |
|
Lathe Setup - by Matthew - 04-22-2021, 08:39 PM
RE: Lathe Setup - by Jack - 04-24-2021, 05:52 PM
RE: Lathe Setup - by Tomer - 05-02-2021, 09:08 AM
RE: Lathe Setup - by Matthew - 05-04-2021, 09:46 PM
RE: Lathe Setup - by Matthew - 05-06-2021, 09:23 PM
RE: Lathe Setup - by Tomer - 05-09-2021, 11:23 AM
RE: Lathe Setup - by Matthew - 05-13-2021, 11:22 PM
RE: Lathe Setup - by Tomer - 05-14-2021, 05:23 AM
RE: Lathe Setup - by Matthew - 05-14-2021, 09:05 PM
|
Browsing: 1 Guest(s)